Create a dormer opening.
Revit joining too different roof.
As revit does its roof calculations to the underside of the roof it is the inside intersection that is perfectly centred between the 2 walls and not the external intersection ridge.
Use it to extend the dormer roof to the main roof.
You cannot join a roof to more than one top face of another roof.
This is a general procedure for joining roofs.
You can adjust this of course but as there are 2 differing slopes assuming the roof thickness is the same for both slopes it is of course impossible for both junctions to be centred.
In other words i want to enter the plan angle and the side elevation angle as.
I ve been trying to figure out how this can be done.
Enjoy the videos and music you love upload original content and share it all with friends family and the world on youtube.
You can join a roof to the top face of another roof and the wall below that roof if you select the wall as the target.
Select join roof tool then select gable edge then select main roof.
Select the main roof then click on dormer walls and roof.
Click edit footprint to enter the sketch mode.
To do this method you need to select the roof and edit the roof footprint.
Changing the slope angle.
This tool is located in the modify tab.
Located in the architecture tab this tool is used to create a dormer shaped hole in the main roof.
Select the small roof select the line the one you want to run into the other roof uncheck define slope and make it a gable then join to other roof will work.
Use join unjoin roof tool.
The wall must be attached to the target roof and the target roof must be a footprint roof.
Select the edge and change the slope value.
I need a suspension rod a simple extrusion or swept profile to hold up a canopy with the angle from mounting point to support point and the angle of rotation off the center of the mounting point flexible.
Enjoy the videos and music you love upload original content and share it all with friends family and the world on youtube.
