Restore Table Top Finish Mixed Hardwoods Surface

How to restore the wood finish on a dining room table.

Restore table top finish mixed hardwoods surface.

Skip the varnish and go straight to the finish to save money. A nice smooth wood surface will readily accept your stain and it will color evenly. Restor a finish can be used on lacquer shellac and varnish and all other clear coat finishes. You must sand with the grain in the same direction as the wood grain.

General finishes sgqt arm r seal urethane topcoat great finish for kitchen table top. First make sure you sand the wood even if you don t see any sort of finish or top coat. Spray evenly in a back and forth motion for a smooth professional appearance. Then buff the surface with a soft cloth.

Fill a paint sprayer with water based lacquer finish and coat the tabletop. Standard brush on polyurethane varnish works well as a tabletop finish. You can buy it in a variety of sizes which can help reduce waste if you re refinishing a very small or very large kitchen table. Anyone who has ever had a varnished or lacquered tabletop has probably experienced the sheer horror of picking up a hot dish to find a ghostly.

The end grain of wood soaks up finishes and often turns much darker than the face grain. For shallow scratches on an otherwise sound shellac or lacquer finish reamalgamation can be used to restore the finish. Apply your color or stain or better yet no color at all. Allow to dry for at least 24 hours before use.

How to repair table top varnish with heat damage. Now wipe down your table with a tack cloth so it s free of dust then go at the surface again this time with your 120 grit. 0000 steel wool stroking very lightly along the grain of the wood. If you get an ugly result pretreat the end grain with a dose of finish that will limit absorption wood conditioner sanding sealer shellac or polyurethane thinned 50 percent.

Arm r seal oil based topcoat is a tough long lasting wood finish that comes in a can with a pry off lid. Start with a coarse grit and end with a fine grit for best results. While not as bulletproof as a conversion varnish it is more than adequate for most conditions. Check for this on your test block.

Spray slightly under the table to ensure the edges are covered. Polyurethane is harder for restor a finish to penetrate into than other finishes like lacquer but it will still clean the surface and make it look much better. I finished my dining table in that way 30 years ago and despite daily use it still looks almost as good as the day i brought it into the house.