With wood filler that can be sanded and painted perhaps.
Removed carpet now door is too short.
My question can the jamb somehow be repaired.
Sometimes carpenters can fill that space in with wood and since its painted it would hide the fact that its a sliver of wood down there.
Don t throw your doors into a landfill after a floor remodel because they are too short.
Fix them with the wood door extender.
Once the much thinner laminate and underlayment was installed it became painfully obvious.
A couple of plinth blocks will take up the slack.
Is it faster.
Prior the carpet was plusher and made the gap in this one door jamb less obvious.
I had the same problem on a few doors when i had the carpeting removed and laminate installed.
Here are some pics.
The flooring is hardwood also i do not have central air heat.
If you remove old carpeting or a built up floor and now the door trim is a bit too short don t fret.
What should i do.
Hi folks after removing my old wall to wall carpeting i have a three doors in my house with a gap at the ground ranging from 1 to 2.
Caulking won t affect the flooring but its caulk and doesn t last forever and dirt sticks to it.
Kwfloors apr 26 2017.
The door jamb and molding are now too short.
They are even made from recycled woods.
I ve just had new carpet fitted with thick underlay but as soon as fittter had left and i went to close sitting room door i realised carpet is too high and the door had to be forced hard to close.
Cut the filler piece so it is the same width as the door.
These decorative square wood blocks often found in older homes are used at the corners and bottom of wood trim.
That or replace the whole door and trim.
Door jamb molding i m pretty sure i am going to replace the molding anyways to a more modern style.
It s low cost made from wood easy diy install no screws no need to take door off hinges.
Cut the filler piece 1 2 to 1 inch shorter than the gap between the floor and door with a wood or circular saw.
Matthews straight away and they said i ll have to get the door shaved i am reluctant to do this as it s a really old door.